Skynvort FX Buffered Splitter Klon Style TL072 Op-Amp Guitar Buffer Pedal JHS Style Handwire

This is a hand-built, low-noise buffered splitter designed to split your instrument signal into two distinct paths without tone loss, high-frequency roll-off, or signal degradation. By combining an active input buffer with dual low-impedance outputs, this unit allows you to drive two amplifiers, separate signal chains, or a tuner and an amp simultaneously while maintaining pristine signal integrity.

It's basically a JHS Pedals Buffered Splitter but instead of having the JHS Little Black Buffer it has a Klon-Style Buffer(TL072)

Technical Specifications

• Circuit Architecture: Utilizing a high-fidelity TL072 dual operational amplifier, chosen for its low noise floor, transparent frequency response, and the capability to cleanly drive multiple output stages.
  
• Routing & Splitter Design: Input -> Buffer -> Out A / Out B. The incoming signal is immediately conditioned by the buffer to eliminate cable capacitance loading, and then split into two independent, buffered outputs to feed two separate destinations without volume drop or impedance mismatching.
  
• Impedance Matching: Features a high input impedance to properly load guitar pickups without coloring the tone, paired with dual low output impedances to drive long cable runs or multi-amp rigs effortlessly.
  
• Enclosure & Layout: Housed in a compact, rugged aluminum enclosure with a brushed industrial finish. Designed for maximum space efficiency on crowded pedalboards.
  
• Hardware: Features independent, chassis-mounted input and dual output jacks on the sides, alongside a top-mounted DC power jack.
  
• Indicators: Equipped with a mounted LED status indicator.
  

Power Requirements

• Voltage: Standard 9V DC
  
• Polarity: Center-Negative
  
• Power Supply: Not included