Rockboard MOD3 V2 3xTRS 3xXLR Pedalboard Patchbay + IEC Power Patch Cable

Route your audio and power cleanly through your pedalboard with a single, organized connection point. This kit pairs the RockBoard MOD patchbay with an IEC patch cable, allowing you to link the module’s power inlet to your pedalboard’s internal power supply while routing your audio connections through the front panel. Designed for clean setups where both signal and power need to be accessible and properly managed.

Rockboard MOD3 v2 All-in-One TRS & Stereo XLR Patchbay 
Rockboard Power Ace IEC Connection Patch Cable 35cm 13.75in

Plug into the space on the back of your compatible Rockboard pedalboard, or remove the faceplate and mount on top of any board for easy routing of cables to the back of your board.

• fits MOD slots in RockBoard pedalboards
• compatible with a wide variety of other pedalboards
• acts as central access point to your effects setup
• establishes clean cable paths to and from the pedal board
• detachable front plate for mounting on top or underneath pedalboards
• 3 x 6,3 mm / 1/4" TRS thru
• 2 x XLR thru (male front / female back)
• 1 x XLR thru (female front / male back)
• 1 x DC 2,1 x 5,5 mm barrel thru
• 1 x AC IEC thru (male front / female back)
• all connections mirrored on backside
• dimensions with front plate (W x D x H) 175 x 85 x 47 mm / 6 7/8" x 3 3/8" x 3 15/16"
• dimensions without front plate (W x D x H) 160 x 85 x 33 mm / 6 5/16" x 3 3/8" x 1 5/16"
• weight 450 g / 0.99 lbs
• incl. mounting screws, counter nuts and TX wrench