Good morning,

Sell boost KSR

Boost / 3-band equaliser

EROS is not a boost like the others. It allows you to amplify a clear sound without overdrive, to add a little

Of grain or introduce distortion. It has an active 3-band equaliser for precise adjustment.

Place it upstream of your amp or preamp to add volume or grain to a clear or crunch channel

. You can also model the distorted response of your amp, as you would with a classic boost.

However, you are no longer limited to a narrow frequency range dictated by a simple tone control

That can be found on many classic boosts.

Similarly, use it before or after the CERES / VESTA or any other preamplifier to benefit from even more control

End on its sounds, and in order to make the most of it according to the configuration of your power amplifier

.

Characteristics:

- Pedal of boost effects / equaliser

- Perfect for pushing any amp while using drop or extended range tuned guitars

- Designed to run in clear boost, add some grain or distortion and offer

Additional control over the sound of your preamp

- Internal gain stages stacked to mimic the behaviour of large tube amps

- Active 3-band equaliser – for detailed sound modelling

- Backlit status indicator with KSR logo

- True Bypass Switching

- Compact size, suitable for pedals

- Made in the United States

It is not a "simple TS-type boost"; it should therefore not be adjusted in this way,

For example, do not put the Level all the way out and do not reduce the Gain. Start with the two set at noon and leave from there.

The "Feel" (tight/greasy/thick) and "Mode" (light/clip/sat) switches will lose their effectiveness

As the Gain potentiometer is lowered.

In addition, the more the Level is pushed to the fullest, the greater the internal distortion can be in the

Last stage of gain, which will add distortion within the EROS, in combination with a

Higher Gain setting. With a lower Gain setting, the last stage will not saturate, but a very powerful signal

Will saturate the input of any amp. This signal may be too powerful to obtain the

It's desired. For example, excessive saturation due to a lack of dynamic margin in the first stage of the amp.

In summary, all settings interact with each other, and there are countless ways to use this

Pedal.

Do not hesitate to test and share your results!!

Required power supply: 9 V DC, 200 mA, negative pole in the centre