KHDK Electronics Annihilator II by Doyle Wolfgang von Frankenstein

KHDK Annihilator II Glowing Octatone & Boost Multipedal by Doyle Wolfgang von Frankenstein

The KHDK Annihilator II combines a precisely controllable octave-down effect with an independently operated boost in one uncompromising pedal. Its new Octatone control allows you to shape the octave-down sound from deep sub-bass tones to an aggressive, synth-like character.

Three separately controllable signal paths offer extensive tonal flexibility — whether you want the pure octave-down signal, a boost, or a combination of both.

And the highlight: the pedal glows in the dark.

This strictly limited edition is limited to just 250 units worldwide. Each pedal was built and tested in the KHDK workshop in Prague and finished with a special glow-in-the-dark powder coating.

Specs

CONTROLS

DIRECT adjusts the volume of your dry, original, unaffected signal. 

OCTAVE (knob) adds a signal shifted one octave down. It is an analog circuit with exceptional tracking, keeping your tone clear and treble-free. It works great on low tunings and is excellent with a bass guitar as well. Do you need to activate it with the Octave switch?

OCTATONE is an active sweepable low-pass filter that is applied to the OCTAVE signal only. Turn it clockwise for an edgier and more aggressive, synth-like sound. Turn it anti-clockwise for a smoother and deeper sub-bass sound. The center setting is the ideal mix of both. OCTATONE does not affect your DIRECT sound.

BOOST (knob) boosts the mix of the three signal paths (direct + octave + octatone). Activate it with the Boost switch. For soloing, you can use a pre-set, transparent tone, activated by turning your BOOST on. Does that mean they should leave the knob in center position?

The volume of each path can be adjusted by DIRECT and OCTAVE pots. 

INPUT is for your guitar cable. 

OUTPUT is for your amp cable or for the next effect in your signal chain. 

TECHNOLOGY

The Annihilator is an analog pedal with high-end components and true-bypass switching.

POWER

To power the Annihilator, use a fresh 9V battery or a clean power supply 9V DC, 2.1mm center negative connector.

If using a battery, always remove the input jack cable when not playing to prevent battery drain.

Neither is included.

When using a battery, always unplug the instrument cable from the INPUT jack after playing to prevent unnecessary battery drain.

Condition: Used / Excellent Condition

Included: Original packaging

All used pedals are carefully prepared before resale:

✓ Thoroughly inspected and tested
✓ Professionally cleaned