The Furman M-8S Power Conditioner is the perfect low-cost AC power solution for any rack mount system. While preventing excessive inrush currents with power sequencing and noise filtering and reducing RF and electromagnetic interference, the M-8S ensures the safety of your equipment.

The Furman M-8S Power Conditioner is a rack-mountable AC power solution for your system. Install the Furman M-8S Power Conditioner in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-Amp load. The Furman M-8S Power Conditioner is the perfect low-cost AC power solution for any rack mount system where power sequencing is desired. Install the Furman M-8S Power Conditioner in to the top slot of your rack, and the six delayed outlets in the rear panel will power up sequentially and protect all your equipment up to a 15-amp load. Includes 3 delayed outlet banks - each with 2 outlets - plus 2 unswitched outlets.

Furman M-8S Power Conditioner Features

• Standard level AC protection and filtering
• Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet
• Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only)
• All settings and configurations available on rear panel
• Noise filtering to reduce radio frequency and electromagnetic interference
• Surge protection feature ensures equipment stays safe
• Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters
• 15 Amp rating with circuit breaker

Furman M-8S Power Conditioner Specifications

• Maximum Output Current: 15 Amps, 120 VAC (Thermal breaker)
• Line Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
• Standard Level AC Surge Protection: Merit Class (sacrificial)
• Spike Protection Mode: Line to neutral, zero ground leakage
• Max Continuous Operating Voltage: 130V RMS
• Max Clamp Voltage: 500 Volts Peak
• Peak Impulse Current: 12,000 Amps
• Energy Rating: 225 Joules
• AC Filtering: Standard level Pi LCR Filter
• Noise Attenuation: >26dB, 100 KHz to 1 MHz
• Operating Temperature Range: 5C (40F) to 40C (105F) degrees
• Humidity Range: <90% rH (Relative Humidity)
• Rocker Switch: Front panel, Sequence (ON, OFF)
• Thermal Circuit Breaker: Front panel, push to reset
• Front Panel Indicators: Delay 1, Delay 2, Delay 3, Power, Protection OK
• Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained
• Potentiometer: Rear panel, time calibration fine tune delay adjust
• Remote Terminal: +5-30VDC In, 12VDC (12mA) Out
• Power Consumption: 5 Watts
• Dimensions: (L x D x H) 19" x 8.75" x 1.75" ANSI 1RU
• Weight: 7 lbs.

Furman M-8S Power Conditioner Includes

• Furman M-8S Power Conditioner
• Manufacturer Warranty