Jackson Ampworks Newcastle 30 head and matched Jackson 1x12" cabinet in pristine condition ( 120 or 240V)

This Jackson ministack is in perfect working condition and as shown, it is visually close to perfect.

----------------------

About Manufacturer

Jackson Ampworks is a small boutique amplifier shop located just north of Fort Worth, TX. Our daily focus is to deliver the best sounding, most reliable and musical sounding instruments possible that inspire the player to greater heights in his/her craft.

Sound Pure is excited to bring Brad Jackson and the wonderful people at Jackson Ampworks to our inventory and we think you'll drool once you hear some of these rigs!  

Manufacturer's Description from Jackson Ampworks

NewCastle 30

At the request of many NewCastle users, we are pleased to release the new higher powered version of the NewCastle called the NewCastle 30! The NewCastle 30™, which offers all of the features of the original NewCastle has been upgraded with 30W of EL84 driven Class A power, an FX Loop and a Variable Power Supply which allows the amp to be adjusted between 30W and 1/8W seamlessly without any tonal change!

Simple Is Better.
The NewCastle 30 is a lesson in simplicity. Someone once asked us, “What’s your secret to great tone?” Answer: “Use good parts, and use as few as possible.” That is what the NewCastle 30 is all about. The design was purposefully kept simple to make it easier to dial in and to keep your tone as pure as possible.
Fully Featured.
The front panel features a single Input, Volume and Tone controls and the addition of a Power control. The Volume control acts as both a Volume as well as a gain control. The higher you run the Volume the more the amp will overdrive in response to how hard the player attacks the strings. The Tone control acts as a master tone control for the entire amp and works similar to the tone control on a guitar. Rotating the Tone control clockwise will increases the high-end response of the amp and conversely rotating the Tone control counter clockwise removes high-end response from the amp which helps when a darker tone is desired or with bright sounding guitars. The full clockwise position removes the Tone control from the amplifier circuit to keep your original tone as pure as possible.
The Power control on the front of the amp is where you can adjust to total output of the amp. Not a master volume though! While the Power does control the overall volume of the amp it does so by varying the high voltage of the amp from full power, 30W Class A to 1/8W Class A. We suggest starting with the Power control at the 30W setting (fully clockwise) and adjusting lower as needed for the band or room you are playing in. Lower settings on the Power control will allow you to increase the Volume control for more gain while keeping the overall volume of the amp at a reasonable volume.

Like the front panel, the back panel is kept very simple. There are two speaker out jacks with an impedance selector switch that provides outputs of either 8 or 16 ohms. Located next to that are the Power and Standby switches as well as an IEC module with an integrated fuse and a switch for selecting between 120V and 240V operation. With the NewCastle 30 you’ll never have to worry about traveling on the road since the amp is designed to work at all line voltages!
 To make the NewCastle 30 even more flexible, we have incorporated a series FX loop between the preamp and power-amp. Adding an FX loop here allows the player to use his/her effects in the loop and not interfere with the critical relationship between the guitar and preamp.

Specifications30W Class A – 1/8W Class A

• (2) – 12AX7 Preamp Tubes
• (4) – EL84 Output Tubes

- Mallory 150 Series Capacitors
- Cathode Bias
- Genuine Carling Switches
- Carbon Film Resistors
- Custom Wound Overspec Power and Output Transformers
- 13 Ply Baltic Birch Cabinet with Dovetail Joints
- Handwired Turret Board Contruction
- Anodized Aluminum Chassis
- Genuine Neutrik Jacks
- Laser Engraved Stainless Steel Panels
- Switchable 120V/240V Operation
Front Panel Controls:

• - Input
• - Volume
• - Tone
• - Power

Rear Panel Controls:

• - FX Loop
• - Speaker Jacks
• - Impedance Selector (8/16)
• - Power
• - Standby