PICK UP IN BROOKLYN, NY.

Works perfectly. Great bass tone. Has only minor wear cosmetic wear.

Specs:

*Power Output: 60 watts into a solid-state power block.

*Speaker: Single 12-inch heavy-duty speaker.

*Equalization: Passive 3 or 4-band EQ (Low, Mid, High, and Presence controls) plus a Bright switch (+6 dB at 2 kHz).

*Inputs/Outputs: High and Low gain instrument inputs (to accommodate active and passive basses), pre-amp output, power amp input (effects loop), and a headphone jack.

*Protection: Built-in DDT (Distortion Detection Technique) speaker compression/protection circuit.

*Weight & Build: Roughly 45 lbs housed in a rugged, wood-cabinet combo structure with a metal grille.

From the manufacturer:

Rated Power & Load:

50 W RMS into 8 ohms with

DDT™ compression and LED

indicator

Power At Clipping: (typically

5% THD, 1 kHz, 120 VAC

line)

57 W RMS into 8 ohms

Frequency Response:

+0, -2 dB, 60 Hz to 10 kHz at

50 W RMS into 8 ohms

Total Harmonic Distortion:

Less than 0.2%, 100 mW to

50 W RMS, 60 Hz to 10 kHz,

8 ohms; typically below 0.1%

DDT™M Dynamic Range:

Greater than 16 dB

DDT™M Maximum THD:

Below 0.5% THD for 6 dB

overload

Below 1% THD for 16 dB

overload

Hum & Noise:

Greater than 90 dB below rated

power

Power Consumption:

(Domestic)

150W, 50/60 Hz, 120 VAC

Preamp Section:

The following specs are measured @ 1 kHz.

with the controls preset as follows: Push

Bright Off (Out): Post Gain @ 10; Low EQ

@ 10; Mid EQ @ 0; High EQ @ 10; Presence

EQ @ 5; Nominal Levels are set with Pre Gain

@5; Minimum Levels are set with Pre Gain

@ 10.

Preamp High Gain Input:

Impedance: High Z, 220 K ohms

Nominal Input Level: -24 dBV,

60 mV RMS

Minimum Input Level: -46 dBV,

5 mV RMS

Maximum Input Level: +6 dBV,

2V RMS

Preamp Low Gain Input:

Impedance: High Z, 44 K ohms

Nominal Input Level: -18 dBV,

120 mV RMS

Minimum Input Level: -40 dBV,

10 mV RMS

Maximum Input Level:

+12 dBV. 4 V RMS

Preamp Output:

Load Impedance: 10 K ohms or

greater

Nominal Output: 0 dBV,

1 V RMS

Power Amp Input:

Impedance: High Z, 22 K ohms

Designed Input Level: 0 dBV,

1 V RMS

System Hum & Noise At

Nominal Input Level: (20 Hz

to 20 kHz, unweighted)

74 dB below rated power

Equalization:

Low, Mid, High, & Presence

Passive Type EQ

Bright: +6 dB at 2 kHz