Vintage Peavey Automixer 4-Button Footswitch (6-Pin DIN) - Like New Condition

Reverb Product DescriptionOverviewUp for sale is a rare, vintage Peavey Automixer 4-Button Footswitch in very good condition. This is the highly sought-after factory original pedal used to remotely run iconic Peavey guitar amplifiers from the late 1970s and 1980s. Finding one in this crisp, un-gigged cosmetic and structural state is incredibly tough.

Specifications & Cord LengthCord Length: Features a heavy-duty, hardwired 15-foot cable providing plenty of slack to stretch across large stages or studio rooms.

Connector Type: Factory-original 6-Pin DIN Male Plug. All 6 internal pins are perfectly straight, tight, and completely free of corrosion or damage.

Enclosure: Rugged, classic heavy-duty chassis built like a tank. Functions & Control Layout

Selector: Instantly switches your instrument signal between the Normal Channel and the Effects/Overdrive Channel.

Combiner: Melds both independent channels together simultaneously for a massive, blended tone layer. (Note: Engaging the Combiner overrides the Selector switch status).

Reverb: Remotely toggles the amplifier’s internal analog spring reverb tank on/off globally.Phase: Actively triggers or cuts the amplifier's built-in analog phaser circuit.Amplifier Compatibility

This foot controller is explicitly compatible with vintage solid-state and hybrid Peavey amplifiers equipped with a rear or front panel 6-Pin Remote Footswitch Jack, including

Quick Setup Instructions Turn off your amplifier's main power switch before connecting. Align the blank gap and outer shield notch on this 6-pin DIN cable plug with the internal guide notch on your Peavey amp’s "Remote Footswitch" jack. Push straight in smoothly.Turn on your amplifier. Set the manual channel toggle switches on the front faceplate of your amplifier to their "In" positions to hand over total switching authority to the floor pedal.