Decksaver DS-PC-KEYSTEPPRO: A Rigid Lid for Your Sequencing Hub

The Decksaver DS-PC-KEYSTEPPRO is a custom-molded polycarbonate protective cover cut to the exact contours of the Arturia KeyStep Pro polyphonic sequencing controller keyboard. Precision-trimmed from a single sheet of impact-resistant smoked-clear polycarbonate, it drops over the unit in seconds and shields the 37 slim keys, the step buttons, the encoders, and the capacitive touch strip from dust, spills, and the knocks of a working studio. For the producer whose KeyStep Pro is the brain of a modular and hardware rig, it is the assurance that the hub of the setup stays reliable.

Why Molded Polycarbonate Beats a Soft Sleeve

Polycarbonate is the same rigid material class used for machine guards and safety glazing, with an impact resistance many times that of acrylic, so a dropped patch cable, a stacked module, or a stray elbow spreads across the hard shell instead of reaching the keys and buttons beneath. Because the cover holds its own molded shape, it also resists crushing force from gear set on top, where a limp cloth would transmit that weight straight down onto the slim keybed and the step buttons. That rigid barrier matters most in a modular rig, where the KeyStep Pro often lives crowded by cases and cables.

Guarding the Slim Keys, Step Buttons, and Touch Strip

The KeyStep Pro packs a 37-note slim keybed, sixteen backlit step buttons, five LED encoders, an OLED display, and a capacitive touch strip into a low chassis, and every one of those is a precision surface that suffers from contamination. Grit under slim keys causes uneven travel, dust in the step buttons dulls their click, and a filmed-over touch strip loses the smooth response that makes its looper feel intuitive. The close-fitting Decksaver shell seals the whole top surface, keeping the keybed, buttons, and touch strip clean so the controller performs the way it did new.

Cables Stay Plugged, Patches Stay Intact

Thoughtful cutouts let you leave the dense rear cabling connected while the cover is in place, so a KeyStep Pro wired to its CV, gate, and MIDI outputs, clock, sustain, USB, and power can be capped at the end of a session without pulling a single patch. That is a real advantage on a controller with this many connections, where re-patching a modular clock and CV routing is exactly the kind of setup you do not want to repeat. The slim form slides into a bag or stacks under other gear, adding a hard layer without adding bulk.

Who the DS-PC-KEYSTEPPRO Is For

DAWless and modular producers use it to cap a KeyStep Pro that sits permanently at the center of a rig, keeping dust off the keys and touch strip between sessions; performing musicians cap the unit the moment a set ends to keep drinks and stage grime out of the electronics; studios and schools use it to protect a shared controller between users. Anywhere the KeyStep Pro lives on an open desk, one spill or a stack of gear pressed against the panel is the difference between a wipe-down and a repair, and this cover keeps your sequencing hub ready.