Designed for sax, toms, brass and percussion, the PRO 35 excels in high-SPL applications and is ideal for active stage performances. Its extended frequency response captures subtle nuances of the performance. The included UniMount clip permits accurate positioning and provides shock resistance while protecting the element. The microphone's cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of the desired sound source. Product Features: UniMount clip permits accurate positioning, provides shock resistance and protects element Cardioid polar pattern reduces pickup of sounds from the sides and rear, improving isolation of desired sound source Extended frequency response captures subtle nuances of the performance6' (1.8 m) cable permanently attached to microphone Product Specifications: Element: Fixed-charge back plate, permanently polarized condenser Polar Pattern: Cardioid Frequency Response: 50 - 15,000 Hz Low Frequency Roll-Off: 80 Hz, 18 dB/octave Open Circuit Sensitivity: -45 dB (5.6 mV) re 1V at 1 Pa Impedance: 250 ohms Maximum Input Sound Level: 145 dB SPL, 1 kHz at 1% T.H.D. Dynamic Range (typical): 115 dB, 1 kHz at Max SPL Signal-to-noise Ratio: 64 dB, 1 kHz at 1 Pa Phantom Power Requirements: 11-52V DC, 2 mA typical Switch: Flat, roll-off Weight (Microphone): 0.3 oz (8 g) Weight (Power Module): 2.9 oz (81 g) Dimensions (Microphone): 0.98" (25.0 mm) long, 0.40" (10.2 mm) diameter Dimensions (Power Module): 3.66" (92.9 mm) long, 0.74" (18.9 mm) diameter Output Connector (Power Module): Integral 3-pin XLRM-type Cable: 6.0' (1.8 m) long (permanently attached to microphone), 0.10" (2.6 mm) diameter, 2-conductor, shielded cable with TA3F-type connector