[RARE USA-MADE] Seymour Duncan TARA 2x12 100W PA System/Acoustic Electric Guitar Amplifier

This amp is in excellent condition. It is a rare vintage USA-made amplifier from the early 90s 

The Seymour Duncan True Acoustic Response Amplifier (TARA)

This amplifier has been crafted specifically to fill the needs 

of the acoustic guitarist. Every feature has been specifically chosen to give you an unprecedented amount of control over your sound while allowing the flexibility to handle virtually any playing situation. It is truly a performance system design.

The cabinet and speaker system were designed to hi-fi standards, providing very flat transparent sound with an extended bottom end. Each of the two channels will accept three inputs (Mic, Instrument, & Effects Return) while allowing incredible tone shaping with two sets of 5-band graphic equalizers and a contour switch. Anti-feedback controls in both channels have been optimized to allow very high sound pressure levels without annoying feedback. You can play guitar through one channel, sing through the other, and mix your drum machine in through one of the three-buffered effects loops. In short, we think you will find your TARA amplifier has the flexibility to handle any playing situation, from solo club gigs to studio work.

Power Output: 100Watts into 4 ohms. Output Type: Quasi-complimentary Bipolar. Power Amp Signal-to-Noise Ratio: >100dB. Power Amp Sensitivity for Full Power: 0.8V. Instrument Input Impedance: 10 Megohms. Microphone Inputs: Low-Z balanced. Notch Filter Frequency: Notch Filter Cut: 0 - 25dB cut. Dual 5 -Band Graphic EQ Frequencies: 80Hz, 240Hz, 720Hz, 2.2kHz, 6.5kHz. Graphic EQ Operation: + 12dB. Effects Loops: 2 Pre-EQ, 1 Post-EQ. Switchable drive/return level: +4dB / -10dB. Wet/Dry mixing with separate blend controls for each loop. Line Out: Electronically balanced, capable of driving 600ohm load, switchable pre/post EQ. Contour Switch: Enhances sound of piezo-ceramic saddle-type pickups. Output Protection Fuses: 4 Amp Fast blow (5 x 20mm) Voltage Requirements: 100V - Japan 120V - U.S., Canada 220V - Europe 240V - U.K. Weight: Mono - 52 lbs

Dimensions: Mono - 20-5/8"W x 18-3/4"H x 13-3/8" D